This original BabyYarnie crochet pumpkin keychain pattern | easy fall bag charm tutorial is designed independently as a practical crochet baby project with explicit stitch counts, measured checkpoints, and clear finishing. The instructions use US terms and keep every construction decision visible so the finished piece can be checked before use or gifting.
The compact pumpkin begins as a simple sphere, then becomes distinctly ribbed through six evenly tensioned exterior wraps. A closed, slip-stitched yarn hanger carries the hardware independently of the decorative stem and leaves.
Pattern Details
- Hook Size: 2.75 mm
- Finished Size: Pumpkin approximately 3.25 inches wide; 6 inches including hardware
- Gauge: 24 sc and 26 rounds = 4 inches in firm single crochet
- Terminology: US
- Estimated Time: 2–3 hours
- Construction: One 30-stitch stuffed pumpkin, six sculpting wraps, one stem, two leaves, one spiral vine, and one reinforced hardware loop.
- Skill level: Easy
Why You’ll Love This Project
The construction is repetitive enough for a relaxed crochet session while the measured checkpoints help prevent size drift. A washable, smooth yarn keeps the stitches easy to inspect and gives the finished baby project a soft, tidy appearance.
Materials
- Approximately 85 yards burnt-orange DK cotton yarn
- Approximately 25 yards olive DK cotton yarn
- Approximately 12 yards brown DK cotton yarn
- 2.75 mm crochet hook
- Small amount washable polyester stuffing
- One 1-inch metal split ring with swivel lobster clasp
- Four locking stitch markers
- Yarn needle and scissors
Gauge, Measurements, and Planning
The 30-stitch widest round should measure about 5 inches around. Use a smaller hook if stuffing shows and keep both leaves under 1.5 inches long.
Make and wash a gauge swatch before beginning. Measure only after the swatch is completely dry. If the stitch width differs, change hook size rather than pulling the working yarn tighter. Keep a written count at the end of every section so the finished edges remain balanced and the assembly points line up.
Abbreviations and Special Stitches
- ch: chain
- sc: single crochet
- hdc: half double crochet
- dc: double crochet
- sl st: slip stitch
- st(s): stitch(es)
- rnd: round
- inc: work 2 sc in one stitch
- dec: single crochet two together
Special stitch guidance: Pumpkin rib: pass a long orange strand from bottom center to top center around the outside six times at equal intervals. Spiral vine: work 3 sc in each of 12 chains so the strip curls naturally.
Important Notes
- Decorative bag charm only; the metal hardware is a small hard part and must remain completely out of reach of babies and young children.
- Do not use beads, bells, wire, buttons, or glued pieces.
- Mark the first stitch of every continuous round.
- The hardware hanger must be sewn through at least six crown stitches in two passes.
- Inspect the clasp, ring, hanger, leaves, stem, vine, ribs, and closing seam before every use.
Complete Instructions for Crochet Pumpkin Keychain Pattern | Easy Fall Bag Charm Tutorial
Crochet and Stuff the Small Pumpkin
Work in a continuous spiral with orange.
- Pumpkin Rnd 1: Make 6 sc in a magic ring. (6 sts)
- Rnd 2: Inc in every stitch. (12 sts)
- Rnd 3: Repeat [sc, inc] 6 times. (18 sts)
- Rnd 4: Repeat [sc in next 2 stitches, inc] 6 times. (24 sts)
- Rnd 5: Repeat [sc in next 3 stitches, inc] 6 times. (30 sts)
- Rnds 6–12: Sc in every stitch. (30 sts)
- Rnds 13–17: Decrease evenly to 24, 18, 12, then 6 stitches, stuffing firmly before closing.
Sculpt Six Ribs and Add Stem
Mark six equal sections before tightening the wraps.
- Pass a doubled orange strand through the bottom and top centers, wrap it around the outside, and repeat six times at equal intervals.
- Tighten each wrap only enough to form a rib, then knot and bury the ends inside the top center.
- With brown, make 6 sc in a magic ring and work 6 rounds even; flatten the lower end and sew its complete base over the center opening.
- Confirm the pumpkin remains round and every rib wrap is secure.
Make Leaves, Vine, and Hardware Hanger
Keep decorative pieces separate from the load-bearing loop.
- Leaves: Make two in olive. Ch 8; from second chain work sl st, sc, hdc, dc, hdc, sc, sl st. Sew both leaf bases beside the stem.
- Vine: Ch 13 and work 3 sc in each of 12 chains. Sew one end beside the leaves.
- Hanger: With brown, ch 14, pass the chain through the split ring, join into a closed loop, and sl st around the entire loop.
- Sew the hanger base across at least six crown stitches in two passes, keeping the metal hardware above the stem.
Finish and Test the Pumpkin Bag Charm
Test decorative and load-bearing parts separately.
- Weave every yarn tail through several same-color stitches and reverse direction once.
- Pull firmly on the split ring and clasp, then test the stem, leaves, vine, and each rib wrap independently.
- Spot-clean the yarn while keeping hardware dry, air-dry completely, and retire the charm if its hanger loosens.
- Keep this adult decorative bag charm inaccessible to babies and young children.
Assembly and Shaping
The load-bearing hanger is sewn independently across six crown stitches. The stem covers the center, while two leaves and one spiral vine sit beside it without carrying the metal hardware.
Lay every component on a flat surface before joining. Match the marked centers first, then divide each remaining edge into equal sections. Work through both layers with consistent tension and pause after each section to check that the fabric lies flat. This measured approach prevents twisting and keeps decorative details facing the intended direction.
Finishing
- Weave and reverse every tail.
- Check that no stuffing shows.
- Spot-clean and air-dry.
- Inspect hardware and hanger before reuse.
For a polished result, weave each tail through several same-color stitches, reverse direction once, and trim only after the fabric has been gently stretched. Block to the listed dimensions without flattening textured stitches. Inspect joins, borders, straps, and decorative pieces before the project is used or gifted.
Helpful Tips
- Mark six rib positions before wrapping.
- Keep the stem short so it does not hide the hanger.
- Use cotton for crisp leaves.
- Test the clasp on a stationary loop before attaching it to a bag.
Good lighting and a contrasting stitch marker make counting much easier. If a section looks uneven, compare the current count with the previous checkpoint before continuing. Fixing one missed stitch early is faster than compensating later, and it preserves the measurements used by the assembly instructions.
Frequently Asked Questions
Is this a baby toy?
No. The metal split ring and clasp are small hard parts; keep the charm completely out of reach of babies and children.
Can I omit the hardware?
Yes. Omit both the ring and reinforced hanger and use the pumpkin only as inaccessible seasonal decor.
How are the ribs formed?
Six exterior yarn wraps pass between the bottom and top centers and are tightened evenly.
Conclusion
The finished pumpkin keychain pairs a firmly sculpted orange body with crisp leaves, a curly vine, and a separately reinforced hardware loop. The compact construction makes a practical adult fall bag charm.
BabyYarnie Printable Crochet Pattern Card
BabyYarnie — easy-to-follow baby crochet for everyday makers.
Project: Crochet Pumpkin Keychain Pattern | Easy Fall Bag Charm Tutorial
Skill level: Easy Hook: 2.75 mm Yarn: DK
Finished size: Pumpkin approximately 3.25 inches wide; 6 inches including hardware
Card Materials
- Approximately 85 yards burnt-orange DK cotton yarn
- Approximately 25 yards olive DK cotton yarn
- Approximately 12 yards brown DK cotton yarn
- 2.75 mm crochet hook
- Small amount washable polyester stuffing
- One 1-inch metal split ring with swivel lobster clasp
- Four locking stitch markers
- Yarn needle and scissors
Card Instructions
- Crochet and Stuff the Small Pumpkin: Increase an orange sphere from 6 to 30 stitches, work seven even rounds, then stuff and decrease closed.
- Sculpt Six Ribs and Add Stem: Create six evenly tensioned exterior ribs and fully sew a six-round brown stem over the top center.
- Make Leaves, Vine, and Hardware Hanger: Add two olive leaves and a spiral vine, then double-sew a closed reinforced hanger around the split ring.
- Finish and Test the Pumpkin Bag Charm: Reverse every tail, pull-test the reinforced hardware loop and all decorations, then reserve the charm for adult use.
Finish: Check every count, weave in all ends, block to measurement, and inspect each join.
